Cuboid, applies Variable Temperature Control system with firmware V3.0 and 150W output, having Temp-SS316 and customized TCR available now.
It is powered by two replaceable 18650 cells with the new slip-open cover.
Multiple colors, 0.96-inch OLED screen and the new dual-battery bar display make it more practical and attractive catering to your preference.
Upgradeable firmware enables it always up-to-date. Now you can upgrade your Cuboid to 200W via VT Software.
1 * Cuboid (no cell)
1 * USB Cable
1 * Manual
1 * Warranty Card
Size: 42 x 28 x 91.5mm
Output Mode: VW/VT-Ni/VT-Ti/VT-ss316/TCR
Output Wattage : 1-150W
Resistance Range: 0,05 - 1,5ohm για VT mode & 0,1 - 3,5ohm για VW mode
150W Output and Dual Battery Bar
Cuboid uses two replaceable batteries with the new dual battery bar.
The maximum output can be reached to 150W, making it powerful and convenient.
We kindly recommend high-rate 18650 cells with rated discharge current≥25A.
New Slip-open Cover and Battery Reverse Polarity Protection
The new slip-open cover on the bottom enables you change your battery swiftly by pulling the slider over.
With the Onboard Reverse Polarity Protection, it will protect the device from damage in the event of reverse battery installation.
Please pay attention to the positive and negative terminal signs when installing new batteries.
Cuboid comes with the upgradeable firmware.
Having Version 3.00 for Cuboid, Temp-SS316 and TCR are available now.
New Firmware V3.10 for Cuboid
Cuboid can be upgraded via VT Software.
The new firmware V3.10 for Cuboid, making the maximum output up to 200W.
Temp-SS316 Mode Based on the previous Temp-SS mode, we developed the new Temp-SS316 mode.
We kindly recommend you using Joyetech BF-SS316 atomizer heads (0.5ohm/1.0ohm).
Customized TCR Available
Cuboid enables you to adjust TCR values for different materials,
thus further improving the accuracy of temperature control and bringing you the great taste.
There are three options (M1, M2, M3) for you to customize the TCR regarding to the material.
In power-off condition, press the fire button and the right regulator simultaneously for around 5 seconds, then you enter into the TCR set menu:
And here's the TCR Value Range for your reference:
Exquisite 510 Stainless Steel Thread Applied with 510 stainless steel thread and wide border fitting for large capacity atomizers.
Charging & Upgrading
We kindly suggest you take out the cells and charge them with a separate charger.
The micro USB port is on the top of the left side. Connect it with a micro USB cable to charge or upgrade your device.